OTHER FEATURES

GO-TO SEARCH

The Go-To Search feature enables the VCR to quickly locate a counter reading anywhere on the tape. When the VCR locates the counter reading, it will begin playback.

1.Press STOP.

2.Press SEARCH on the remote until the GO-TO SEARCH menu appears on the screen.

3.Press number buttons to enter the hour and/or minute of the counter reading you want the VCR to “go to.” Press CLEAR on the remote to correct an entry.

4.Press FORWARD to search ahead or REVERSE to search behind.

5.Press STOP to end Go-To searching.

GO-TO SEARCH

Current tape counter is 2:17:25

Press REV or FWD to go to -:--:00

Press SEARCH to exit.

GO-TO SEARCH

Current tape counter is 2:17:25

Press REV or FWD to go to 0:00:00

Press SEARCH to exit.

TRACKING

Your VCR has automatic tracking which removes interference like streaks or “snow” from the picture. Automatic tracking is automatically activated when you insert a tape or turn on the VCR. Occasionally you may need to manually adjust tracking, especially if the tape was recorded on a different VCR. Just use the TRACKING buttons to reduce the distortion. You can also use tracking when you pause a tape to reduce jittering of the picture.

When you manually adjust the picture, automatic tracking is turned off. To turn automatic tracking back on, press both TRACKING buttons on the front of the VCR at the same time, or eject the tape and re-insert it. Tracking has no effect during recording– only playback.

If you insert a pre-recorded tape with the safety tab removed-- Index and Go-To searches are not available.

47

Page 49
Image 49
RCA VR646HF manual Tracking, GO-TO Search