SE4
SE5
SE6
English
6. Set up
■CUTTERCASE (SE4)
WARNING
The blade has very sharp edges. Be sure to use protective gloves whenever handling it.
1.Remove the fastening screw(long) and the lock screw(short) from the cuttercase.
2.While aligning the locking holes, install the cuttercase assembly to the shaft casing.
3.Align the locking holes and screw in the lock screw to the bottom by hand, then secure it with the wrench provided. Do not tighten up the lock screw with the holes out of alignment, or the cuttercase can be damaged.
(1)Cuttercase
(2)Locking holes
NOTE
If the locking screw is tightened up with the holes out of alignment, the cuttercase may be damaged.
4. Fasten the cuttercase fastening screw.
■BLADE GUARD
Install the blade guard onto the shaft casing approx. 3cm away from the cuttercase. Fasten the clamp uniformly. (SE5, SE6)
22
