English

8. Operation

OP5

.04 in

(1~2mm) (1)

OP6

(1)

STOPPING ENGINE (OP3)

1.Release the throttle lever and run the engine for a half minute.

2.Shift the ignition switch to the STOP position.

IMPORTANT

Except for an emergency, avoid stopping the engine while pulling the throttle lever.

ADJUSTING THROTTLE CABLE

The normal play is 1 or 2mm when measured at the carburetor side end. Readjust with the cable adjuster as required. (OP5)

(1) cable adjuster

ADJUSTING IDLING SPEED (OP6)

1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.

2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw counter- clockwise.

(1) idle adjusting screw

NOTE

Warm up the engine before adjusting the idling speed.

USAGE

This machine does cutting not by a rotary cutter like conventional trimmers but by a pair of special blades, each upper blade and lower blade oscillate opposite direction alternately within a limited angle at a speed of approximately 1/30 of conventional trimmers.

This unique mechanism brings you many benefits like the following:

1.Since the blade does not cause grass chips and pebbles to the thrown around, you may use less care about your clothing or surroundings.

2.Should the blade hit a rigid object like stones, trees or steel poles during operation, it does not produce a bounce motion that can cause loss of machine control.

3.Since the blade does not cause cut grass to wrap around the neck, you need not to stop operation to remove such wrappers.

32

Page 32
Image 32
RedMax SGCZ2401S-CA manual OP5, OP6 Stopping Engine OP3, Adjusting Throttle Cable, Adjusting Idling Speed OP6, Usage