PROBLEMSOLUTION
4.The walking belt is
a.If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller bolt clockwise 1/2 of a turn. Be careful not to overtighten the walking belt. If the walking belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.
a |
| b. If the walking belt slips when walked on, | b |
| |
| first remove the key and UNPLUG THE |
| ||
|
|
| ||
| POWER CORD. Using the allen wrench, |
|
| |
| turn both rear roller bolts clockwise 1/4 of a |
|
| |
| turn. When the walking belt is correctly |
|
| |
| tightened, you should be able to lift each |
|
| |
| side of the walking belt 3 to 4 inches off the |
|
| |
| walking platform. Be careful to keep the |
|
| |
| walking belt centered. Plug in the power |
|
| |
| cord, insert the key and carefully walk on |
|
| |
| the treadmill for a few minutes. Repeat until the walking belt is properly tightened. | |||
5. The displays of the | a. Remove the key from the console and UN- | a |
| |
console do not func- | PLUG THE POWER CORD. Next, remove |
| ||
1/8” |
| |||
tion properly | the screws from the hood and carefully re- |
| ||
99 | 11 | |||
| move the hood. Locate the Reed Switch | |||
|
| |||
|
| 12 | ||
| (17) and the Magnet (12) on the left side of | 17 | ||
| the Pulley (11). Turn the Pulley until the | Top |
| |
| Magnet is aligned with the Reed Switch. |
| ||
| Make sure that the gap between the | View |
| |
| Magnet and the Reed Switch is about |
|
| |
| 1/8”. If necessary, loosen the Reed Switch |
|
| |
| Screw (99) and move the Reed Switch slightly. Retighten the Screw. | |||
| hood and run the treadmill for a few minutes to check for a correct speed reading. | |||
25
