OPERATING INSTRUCTIONS
COPY OF LIGHTING PLATE INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING |
This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installation Codes, CSA B149.1.
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or gas supplier.
A)BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
-Do not try to light any appliance.
-Do not touch any electric switch, do not use any phone in your building.
-Immediately call your gas supplier from a neighbours phone. Follow the gas supplier’s instructions.
-If you cannot reach your gas supplier, call the fire department.
B)Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
C)This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.
CAUTION: Hot while in operation. Do not touch. Severe Burns may result. Due to high surface temperatures keep children, clothing and furniture, gasoline and other liquids having flammable vapors away. Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
1)Plug the power cord into a power outlet.
2)Press and release the ON/OFF button once on the Remote Control.
3)After approximately 3 seconds the spark ignition system will spark for 30 seconds to light the main burner.
4)If the main burner does not light within 90 seconds, you must reset the unit. See instruction manual for details.
TO TURN OFF GAS APPLIANCE
1)Press the ON/OFF button once on the Remote Control.
2)If service is to be performed, you must disconnect both sources of power to the unit; main power and the battery.
DO NOT REMOVE THIS INSTRUCTION PLATE 918-628
OPERATION
Regency® L676E Direct Vent Gas Fireplace | 35 |
