Regency S2100M, F2100M Recommended Heights for Woodstove Flue, Mobile Home Installation

INSTALLATION

TABLE 1

MINIMUM RECOMMENDED FLUE HEIGHTS IN FEET

(Measured from the top of the unit)

		# OF ELBOWS
ELEVATION (FT)
ABOVE SEA LEVEL	0	2 x 15o	4 x 15o	2 x 30o	4 x 30o	2 x 45o	4 x 45o
0-1000	12.0	13.0	14.0	15.0	18.0	16.0	20.0
1000-2000	12.5	13.5	14.5	15.5	19.0	16.5	21.0
2000-3000	13.0	14.0	15.0	16.0	19.5	17.0	21.5
3000-4000	13.5	14.5	15.5	17.0	20.0	18.0	22.5
4000-5000	14.0	15.0	16.0	17.5	21.0	18.5	23.0
5000-6000	14.5	15.5	17.0	18.0	21.5	19.0	24.0
6000-7000	15.0	16.0	17.5	18.5	22.5	20.0	25.0
7000-8000	15.5	16.5	18.0	19.0	23.0	20.5	25.5
8000-9000	16.0	17.0	18.5	20.0	24.0	21.0	26.5
9000-10000	16.5	17.5	19.0	20.5	24.5	22.0	27.0

NOTE: No more than two offsets (four elbows) allowed. Two 45o elbows equal one 90o elbow.

RECOMMENDED

HEIGHTS FOR

WOODSTOVE FLUE

Simple rules on draft. See Table 1.

1)At sea level minimum height is 12' straight.

2)Add the following vertical height to com- pensate for:

45 deg. elbow = 1 ft.

90 deg. elbow = 2 ft.

"T"= 3 ft.

Each foot of horizontal run = 2 ft.

3)Add 4% overall for each 1000' above sea level.

Example: a)
1-1/2 ft. of horizontal run		= 3 ft.
one "T"		= 3 ft.
Total Addition (at sea level)		= 6 ft.
Example: b)
One 90 deg. elbow		= 2 ft.
2 ft. of horizontal run		= 4 ft.
one "T"		= 3 ft.
Total Addition (at sea level)		= 9 ft.
Recommended Flue Height
Elevation	Example a)	Example b)
0'	18'	21'
1000'	18.72'	21.84'
2000'	19.44'	22.68'
5000'	21.60'	25.20'
8000'	23.76'	27.72'

MOBILE HOME INSTALLATION

Once you have properly marked the position of your unit and the floor protection as outlined in the Residential Installation items #1 through #8, a supply of fresh air has to be supplied to your unit. Cut a minimum 4 inch diameter hole through your floor protector and the floor directly under your pedestal base to the outside. Use 4" duct pipe with a mesh grill to pipe fresh air into the pedestal area. Block off the hole in the back of the pedestal with the square plate and the two 1/2" screws provided.

Place your unit in position and secure it to the floor using two lag bolts 3/8" x 3-1/2" through the two holes inside the pedestal base. It is important to maintain the structural integrity of the Mobile Home floor, walls and roof when installing your unit.

For Mobile Home units installed in the U.S. the unit must be grounded using a #8 ground wire with approved termination and star washer.

14 Regency Freestanding Woodstove