Regency Official Gas Fireplace Manual and Installation Guide

INSTALLATION

LOG SET

INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit contains the following:

a)02-43 Rear Log

b)02-45 Front Right Log

c)02-56 Middle Left Log

d)02-46 Left Top Log

e)02-47 Center Log

f)02-48 Middle Right Log

g)02-44 Front Left Log

h)Embers

i)Rockwool

j)Vermiculite

Note: Install Optional Brick Panels prior to installing logs.

The "02" refer numbers (i.e. 02-43) are

molded into the rear of each log.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite around the fi rebox base. Take some of the embers (approx. 1/3 of the bag) and sprinkle over the vermiculite.

Vermiculite	Vermiculite	Vermiculite
and embers.	and embers.	and embers.

3) Place Rear Log A)02-43 on the two pins on	6) Place the Left Top Log D)02-46 on the pin
the rear log support.	on Log C)02-56 and on top of the cutout
	on Log A)02-43.
A)02-43	D)02-46
		A)02-43
	C)02-56
Pins on Rear Log Support	Pin	Cutout
4) Place Front Right Log B)02-45 on the two	7) Place the notch in Center Log E)02-47 over
pins as shown.	Log B)02-45 and across the cutout on Log
	A)02-43.
	E)02-47	A)02-43
B)02-45
		B)02-45
5) Place the Middle Left Log C)02-56 on the	Notch	Cutout
two pins as shown.

C)02-56

Logs D)02-46 and E)02-47 in position.

8) Position notch in Front Right Log F)02-48 on Log E)02-47 and push the bottom right edge against the bracket on the burner tray and the front edge of the rear burner.

F)02-48

Logs A)02-43, C)02-56, and B)02-45 in position

B)02-45

NotchBracket

10 U32-4 FPI Direct Vent Gas Insert