INSTALLATION
2)If required, adjusting the primary air to ensure that the fl ame does not carbon. First allow the unit to burn for
3)Check for proper draft.
CAUTION:Anyalterationtotheproductthatcausessootingorcarboning that results in damage is not the responsibility of the manufacturer.
CLEARANCES TO COMBUSTIBLES
The clearances listed below are MINIMUM distances. Measure the clearance to both the appliance and the chimney connector. The farthest distance is correct if the two clearances do not coincide. For example, if the appliance is set as indicated in one of the diagrams but the back wall is too close, move the stove until the correct clearance to the connector is obtained.
This appliance may be installed only with the clearances as shown in the situations pictured. Do not combine clearances from one type of installation with another in order to achieve closer clearances. Use the minimum clearances shown in the diagrams.
|
| ||
A | Side Wall to Unit | 250 | mm |
B | Back Wall to Unit | 150 | mm |
E | Side Wall to Unit | 38 | mm |
|
|
|
|
|
|
| |
C | Back Wall to Flue Centerline | 292 | mm |
D | Side Wall to Flue Centerline | 559 | mm |
F | Side Wall to Flue Centerline | 330 | mm |
Minimum ceiling height is 914 mm from top of
unit.
PEDESTAL ASSEMBLY
1)For easier assembly, tip the stove on its back (preferably onto a soft surface to prevent scratching).
2)Unscrew the 4 bolts in the underside of the stove. Align the holes in the corners of the pedestal top with the corresponding holes in the base of the stove. Use washers which are supplied with the pedestal as shown in diagram. Reinstall bolts.
3)Push the Regency® logo into the two holes in the front bottom left corner of the pedestal cover plate.
Note: Any paint touch up should be done prior to placing logo on pedestal.
4)See wiring instructions below.
Diagram 1
6 | Regency® |
