INSTALLATION
Pedestal & Leg/Bottom Shield
Wiring Instructions
1)Disconnect the fan harness plug.
2)Disconnect the 240V power cord from the terminal block
3)Disconnect the three wires from the
4)Install the
5)Install the power cord through the small hole in the rear of the Bottom Shield or Pedestal
6)
7)Ground the power cord and mount the terminal block if required.
8)
9)Connect the yellow wire from the gas valve to the Burner
10)Connect the orange wire from the spill switch to the Burner ON/OFF switch.
11)
12)Secure the power cord with the supplied grommet at the back of the Bottom Shield or Pedestal.
LEG AND BOTTOM SHIELD
ASSEMBLY
These instructions apply to the black, gold and nickel cast legs. It will be easier to attach the legs to the stove if it is tipped on its back (preferably on a soft surface to prevent scratching).
1)Remove the 4 bolts in the underside of the base and discard.
2)Put the bottom shield up against the bottom of the stove and loosely install the four supplied bolts and washers into the threaded holes in the four corners of the bottom the unit. Once the bolts are started, slip the leg under the washer and tighten the bolts.
3)Hook up wires to Burner ON/OFF switch and valve assembly as per wiring instructions above. See Diagram 1.
4)Level the stove by adjusting the levelling bolts in the bottom of each leg.
Regency® | 7 |