Remington Power Tools MPS6017A Mower Information, Mower Assembly, English, Adjusting Wheel Height

MOWER INFORMATION

MOWER ASSEMBLY

Attaching Handle Assembly to Mower

1.Align ends of lower handle assembly with handle shafts on rear of mower (see Figure 1). Insert connector bolts, from the inside of the handle assembly, through both the lower handle assembly and the handle shafts (see Figure 2).

3.Place star-washer onto connector bolt and thread on the handle knobs (see Figure 3). Hand-tighten handle knobs securely.

4.Rotate top of handle assembly upward to align with bottom of handle.

5.Tighten handle knobs (see Figure 4).

Adjusting Handle Height

The handle has three height adjustments (three holes in the lower handle assembly). Adjust the handle assembly to a comfortable height for you.

1.Loosen and remove the handle knobs, con- nector bolts, and star-washer (see Figure 4).

2.Adjust handle up or down to desired height (see Figure 5).

3.Align holes on lower handle assembly with hole in upper handle assembly.

4.Insert connector bolts, from the inside of the handle assembly, through both the lower and upper handle assembly.

5.Place star-washer onto connector bolt and thread handle knobs on loosely (see Figure 4).

6.Verify upper and lower handle assembly are aligned and hand-tighten handle knobs securely. Note: Be careful not to over- tighten handle knobs and possibly strip the threads.

Check the handle height for comfort and adjust as needed.

Figure 1 - Align Lower Handle Assembly

Figure 2 - Insert Connector Bolts

Figure 3 - Thread on Handle Knobs

Figure 4 - Tighten Handle Knobs

Figure 5 - Adjusting Handle

Adjusting Wheel Height

There are 8 preset cutting height settings. The cutting depth of the mower is adjustable from 1 1/2" to 3 1/2" in approximately 1/4" increments. Use the wheel height adjustment handle to adjust all 4 wheels.

1.Remove key from mower.

2.Make sure all four wheels are level.

3.Slide the wheel height adjustment handle out of the slot (see Figure 6).

Note: To easily adjust the cutting height, hold the mower handle with one hand to keep the mower steady and adjust the lever with the other hand.

4.Move the handle forward or backward to adjust cutting height (see Figure 7).

5.Slide the handle into the slot at the desired height (see Figure 8).

Note: Setting 1 cuts the grass to 1 1/2" in height (short cut). Setting 8 cuts the grass to 3 1/2" in height (tall cut).

Figure 6 - Wheel Adjustment Handle

Figure 7 - Move Handle

ENGLISH

Figure 8 - Slid Handle into Slot

9 www.desatech.com