R0E530640MCU00 User’s Manual 2. Setup
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 23 of 229
14 Change the settings. Change the settings of the power supply to MCUs or clock supply,
according to the use condition.
▼
15 Connect the user system. Connect the user system as occasion demands.
▼
16 Turn on the power supply. Turn ON the power to the emulator and the user system as
simultaneously as possible.
▼
17 Check the LED display of the emulator.
Check that system status LEDs, and POWER and RESET of the
target status LED are lighting. When the user system is not
connected, the POWER LED does not light up.
▼
18 Start up the emulator debugger from the
High-performance Embedded Workshop. Start up the High-performance Embedded Workshop to launch the
emulator debugger.
▼
19 Set up the target MCU and system. Check the contents set in the step 12 in Figure 2.1. Do not check
“Start booting up on successful completion of self checking”.
▼
20 Debug a program with various functions of
the emulator debugger Refer to the High-performance Embedded Workshop and “5.
Debugging Functions” (page 78).
Figure 2.2 Flowchart of starting up the emulator (After the self-check)