19
9. Multiplex ing the AUD Pins
The AUD pins are multiplexed with other pins. The AUD function cannot be used for the
initial values because they are used as other functions. To use the initial value as the AUD
function, set the AUD pins to be used from [AUD pin select] of the [Configuration] dialog box.
The emulator rewrites the registers for the pin function controller (PFC) to enable the specified
AUD pins before executing the user program. When those registers are changed by the user
program, note that the settings of the AUD pins will not be changed. For details of the setting
methods and values, ask Renesas Technology Corp. via the sales office.
10. Using WDT
The WDT does not operate during break.
11. Loading Sessions
Information in [JTAG clock] of the [Configuration] dialog box cannot be recovered by loading
sessions. Thus the TCK value will be as follows:
• When HS0005KCU01H or HS0005KCU02H is used: TCK = 1.25 MHz
12. [IO] Window
• Verify
In the [IO] window, the verify function of the input value is disabled.
13. Illegal Instructions
Do not execute illegal instructions with STEP-type commands.
14. Reset Input
During execution of the user program, the emulator may not operate correctly if a contention
occurs between the following operations for the emulator and the reset input to the target
device:
• Setting an Event Condition
• Setting an internal trace
• Displaying the content acquired by an internal trace
• Reading or writing of a memory
Note that those operations should not contend with the reset input to the target device.