
Basic Procedure
29
2
FPlace your originals.
The originals are fed into the ma-
chine.
Important
❒Once the originals start to feed
into the machine, do not push or
pull them. This may damage
your originals.
Note
❒Insert the originals so that the
right edge is aligned with the
original guide.
❒Release the original when it is
pulled slightly into the ma-
chine.
❒Immediately after the machine
is turned on, or if the tempera-
ture is low, or if making a lot of
continuous copies (more than
30 sheets/A0, (more than 30
sheets/E size)), the continuous
copy speed may be down to en-
sure the toner fuses to the pa-
per. This is called CPM down.
❒To stop originals being fed into
the machine, press the {Scanner
Stop} key.
❒When you press the {Scanner
Stop} key, the original stops im-
mediately, which can cause the
original to jam. If this happens,
see P.117 “
x
Clearing Misfeeds”
❒To pause or cancel a copy job,
press the {Clear/Stop} key.
When you press the {Clear/Stop}
key, the machine stops after the
current copy (one sheet) has fin-
ished.
Reference
⇒ P.31 “Setting Originals”
⇒ P.21 “Paper Capacities For
Each Original/Paper Output”
GThe machine starts copying.
Note
❒When Scanner Stop Trigger set-
ting is set to on, copying starts
when you press the {Start} key.
See P.128 “Print Start Trigger”
Original Counter/Reset
After the originals have been
scanned, the number of originals is
displayed in the right corner of the
screen. This allows you to check the
number of originals in a job, or to
check if any sheets have been fed to-
gether, and can also be used as a
guide for the number of copies that
will be stored in the copy output tray.
Resetting the original counter
APress the [Orig.] key and the count
number in the top right corner of
the screen.
The number is reset to 0.
ZEDH150E