Ricoh G700 manual Appendices, Troubleshooting, 106, Error Messages

Appendices

11

11 Appendices

Troubleshooting

Error Messages

If an error message is displayed on the screen, check the information on the reference page and take the corresponding action.

Error Message	Cause and Solution	Refer to
Insert card.	No card is loaded. Insert a card.	P.23
Set date.	The date is not set. Set the date.	P.79
The file number limit has been	The file number limit has been exceeded. Use another card.	P.79
exceeded.
Unmatched File	This file cannot be displayed on the camera. Check the file	—
	contents on your computer, and then delete the file.
Insufficient memory. Continue?	All the files cannot be copied because there is insufficient	P.20
	memory on the card. Use another card.
Protected	The file selected for deletion is protected.	P.72
Card Is Write-Protected.	The card is locked (write-protected). Unlock the card.	P.21
This option is not available with	Selected option is not available with SD WORM cards. Use	P.20
SD WORM cards.	a different type of card.
Print settings cannot be applied	This file (movie or other file) cannot be selected for	—
to this file.	printing.
Insufficient Memory/	Files cannot be stored. Make sure there is sufficient	P.37,
Capacity Short	memory or delete unwanted files.	P.76
	The image print number limit has been exceeded. Select an	P.94
	image and set the number to 0.
Format internal memory.	The internal memory requires formatting.	P.76
Format card.	The card is not formatted. Format the card with this	P.76
	camera.
Card Error	Reformat the card. If the error message still appears after	P.76
	that, the card may be faulty. Do not use the card.
Writing Data	Writing file to memory. Wait until writing finishes.	—
No File	There are no files that can be played back.	—
Out of memory. cannot record.	The number of remaining shots is 0. Switch to another card	P.20
	or the internal memory.
No files to restore.	There are no files to restore.	P.67
Can not —. *	Selected option can not be applied to image more than	—
	once, or image was created with different make of camera.
	If image was created with different make of camera,
	process image using original make of camera.

* “—“ indicates the name of the process that can not be applied.

106