Ricoh GX200 manual 256, Do not forcefully press the surface of the picture display

Appendices

7

Cautions on Use

Cautions on Use

•This product was manufactured for use in the country in which it was purchased. The warranty is only valid in the country in which the camera was purchased.

•Should the product fail or malfunction while you are abroad, the manufacturer assumes no responsibility for servicing the product locally or bearing the expenditure incurred therefore.

•Be sure not to drop or apply any sudden force to the camera.

•While you are carrying the camera, be careful not to hit it against other objects. Take special care to not hit the lens and picture display.

•Firing the flash consecutively may heat the firing unit. Do not fire it consecutively more than necessary.

•Do not touch the flash and keep foreign objects away from the firing unit. Doing so can cause burns and fires.

•Do not fire the flash near eyes. It could cause visual impairment (particularly for infants).

•Do not fire the flash near the driver of a vehicle to avoid causing accidents.

•The batteries may become hot after extended use. Touching the batteries immediately after use could result in burns to your fingers.

•If the picture display or panel is exposed to sunlight, they may become washed out and images may become hard to view.

•The picture display and panel may contain some pixels that do not remain lit up continually in part or at all. Also, the brightness may become uneven because of the characteristics of LCDs. These are not failures.

•Do not forcefully press the surface of the picture display.

•In an environment where the temperature changes suddenly, condensation may occur in the camera, resulting in troubles such as fogging of the glass surface or malfunctions of the camera. If this occurs, place the camera in a bag to slow the temperature change as much as possible. Take it out of the bag after the temperature difference from the atmosphere has decreased to a fairly small amount. If condensation occurs, remove the battery and memory card, and wait until the moisture has dried before using the camera.

•To avoid damaging the connectors, do not put any objects into the camera’s microphone or speaker holes.

•Do not get the camera wet. Do not operate the camera with wet hands. This can result in malfunction or an electrical shock.

256

Conditions in which condensation may easily occur---------------------------

• When the camera is moved to an environment where the temperature differs greatly.

• In humid places.

• In a room immediately after being heated, or when the camera is exposed directly to cooled air from an air-conditioner or another similar appliance.