Assembly (continued)
Installing The Table
1.Loosen support lock and raise table support by turning table crank clock- wise until support is at a working height level. Tighten support lock.
2.Remove protective covering from table and discard. Loosen table lock, place table in table support and tighten table lock (located under table) by hand.
NOTE: If table won’t fit into table support easily, pry open table support with a flat blade screwdriver.
Support Table Lock Support
Column
Table
Support
Support
Lock
Table
Crank
Rack
Table
Table
Lock
Installing the Storage Tray
1.Locate the two piece storage tray, (2) two 5mm dia. x 60 mm long screw, and
(2)two 5 mm hex nuts.
2.Attach to the column as shown. Make sure the storage tray is located above the column collar. Be careful not to over- tighten the nuts.
Pan Head Screw
5mm x 60mm
(Not Actual Size) Hex Nut
5 mm
Storage Tray
Column
Collar
14
