Glossary of Terms
Workpiece
The item on which the cutting operation is being performed.
Drill Bit or Drill
The cutting tool used in the drill press to make holes in a workpiece.
Backup Material
A piece of wood placed between the workpiece and table...it prevents wood in the workpiece from splintering when the drill passes through the backside of the
workpice...also prevents drilling into the table top.
Revolutions Per Minute (R.P.M.)
The number of turns completed by a spin- ning object in one minute.
Spindle Speed
The R.P.M. of the spindle.
Backlash
The amount of handle movement or play between adjacent moving parts.
Motor Specifications and Electrical Requirements
Power Supply and Motor Specifications
WARNING: To reduce the risk of electrical hazards, fire hazards or damage to the tool, use proper cir- cuit protection. Your tool is wired at the factory for operation using the voltage shown. Connect tool to a power line with the appropriate volt- age and a
The
Rated H.P | 1/2 |
|
|
Voltage | |
|
|
Amperes | 8.0 |
|
|
Hertz (Cycles) | 60 |
|
|
Phase | Single |
|
|
RPM | 1700 |
|
|
Rotation of Shaft | Clockwise |
|
|
General Electrical Connections
DANGER: To reduce the risk of electrocution:
1.Use only identical replacement parts when servicing. Servicing should be performed by a quali- fied service technician.
2.Do not use in rain or where floor is wet.
This tool is intended for indoor residential use only.
WARNING: Do not permit fin- gers to touch the terminals of plug when installing or removing the plug to or from the outlet.
SYMBOLMEANING
Do not expose to rain or use in damp locations.
SAVE THESE INSTRUCTIONS
7
