1.Remove the air compressor from the carton.
2.Place the compressor on a secure, level, and stationary work surface and look it over carefully.
3.Make sure the dipstick is in a plastic bag secured to the pump.
4.The pump has been filled with the appropriate amount of oil (250 mL / 8.4 oz) by the factory.
5.Replace the plug with the dipstick located inside the bag. Check the oil level using the dipstick.
6.If the oil level is below the “MIN” line, fill the pump until the oil level reads between “MIN” and “MAX” lines. (For oil type and fill directions, see “Lubrication” section in the manual)
!WARNING:
For your own safety, never operate unit until all assembly steps are complete and until you have read and understood the entire operator’s manual.
!WARNING:
To reduce the risk of injury, if any parts are missing, do not attempt to operate the air compressor until the missing parts are obtained and installed cor- rectly.
!WARNING:
Do not operate unit if damaged during shipping, handling or use. Damage may result in bursting and cause injury or property damage.
Installation
1.Check and tighten all bolts, fittings, etc., before operating compressor.
2.Make sure compressor is filled to proper oil level before use.
3.Operate compressor in a ventilated area so that compressor may be properly cooled.
4.Compressor should be located where it can be directly plugged into an out- let. An extension cord should not be used with this unit.
5.To avoid loss of power and overheat- ing, additional air hose must be used to reach work area instead of exten- sion cords.
10