SeekTech
the Main Menu, they will not appear when using the Frequency Key to cycle through frequencies.
Frequencies which appear in the Main Menu and are checked for activation are called
Frequencies that are
Frequencies currently available by default include:
Sonde Mode
•512 Hz*
Active Line Trace Mode:
•128 Hz*
•1 kHz*
•8 kHz*
•33 kHz*
•93 kHz*
•262 kHz*
Power (Passive Line Trace Mode):
•60 Hz (9th) *
•< 4 kHz *
Radio Frequency
•4
•15 kHz – 35kHz (H) *
OmniSeek
(* =
Keypad
Figure 7: Keypad
• Power/Right Key – Powers
• Up and Down Keys – Used for locating choices during menu selection; used for setting volume level when the Volume Control Key has been pressed. If Signal Focus is activated, the Up and Down Keys will change the Signal Focus setting up and down.
• Select Key – Used to make a choice during Menu selection; in normal operation, to force a Measured Depth reading and re- center audio tone. Can be used to force a
• Menu Key – Used to display a “tree” of choices including frequency selections, display element choices, brightness and contrast, and restoring default settings. In a menu, will move up one level.
• Volume Control Key – Used to raise or lower the volume setting; will cycle the volume by steps, increasing to maximum and then mute. Pressing the Volume Key opens the volume control panel if it is closed. When open, the control panel will close after ten seconds if no keys are pressed. Volume can also be raised and lowered using the Up and Down Keys when the Volume screen is open.
Ridge Tool Company Elyria, Ohio U.S.A | www.seektech.com | 9 |