MULTI-NET FEATURES

other selectable systems. While searching is occurring, “ROAMING” is indicated on the lower line of the display as shown below. When a new site is located, this message is no longer displayed, and the system and group of the new site is displayed.

The new system is the first higher system with a different site that could be accessed (wrap-around occurs after the highest system is accessed). The new group is either the same group that was displayed before roaming occurred or the last selected group of that system (programming determines which is selected).

Transmitting Status Messages

Preprogrammed status messages can be transmitted whenever the transmitter is keyed with a Multi-Net system selected. If this feature is available, the STATUS menu parameter (see page 33) is programmed to allow the desired message to be selected.

Selecting the STATUS menu parameter enables the status message select mode. This mode is indicated by “STATUS” on the top line of the display and the bottom line indicates the currently selected status message (see following illustration).

Status Select Mode

Selected Status

Message

To change the current message, press the Select switch. When “NO STAT” is selected, no message is transmitted. To select the current

45

Page 45
Image 45
EFJohnson 002-9800-401 manual Transmitting Status Messages, Status Select Mode Selected Status Message