GENERAL OPERATION

System Select

 

Group Select

Mode

 

Mode

 

 

 

Select Mode Indication With Alpha Tag Display

The transceiver can be programmed so that after a change is made, the current select mode remains enabled or a default mode is selected after a delay of up to 15 seconds. This programming also controls the mode that is selected when power is turned on.

Setting Squelch Control

NOTE: This sets the squelch level used for conventional calls. The squelch level for Multi-Net and LTR calls is preset and not affected by this adjustment. For more information on the various operating modes, refer to page 40.

If conventional systems are programmed, the squelch level can be set if the FCN option switch is enabled. Proceed as follows:

1.Select a conventional system and then a group that is not busy. Take the microphone off-hook to enable monitoring.

2.Press the FCN switch and then rotate the Select switch as you would a normal squelch control. Rotate it counterclockwise until receiver noise is heard and then clockwise slightly past the point where the noise mutes. The squelch adjust mode is indicated by “SQUELCH” on the upper line of the display, and the relative squelch level is indicated by a bar graph on the bottom line.

3.To select the current level and exit this mode, press the Select switch. This also occurs automatically 2 seconds after no change is made or 8 seconds after no activity.

18

Page 18
Image 18
EFJohnson 002-9800-401 manual Select Mode Indication With Alpha Tag Display, Setting Squelch Control