EFJohnson 002-9800-401 manual Telephone Calls Other Special Calls, Placing Telephone Calls

TELEPHONE CALLS AND OTHER SPECIAL CALLS

2.Select or scan the system and group programmed for the call you want to receive (see page 35 for scan information).

3.When the message is received, the display usually changes to the system and group of the call. Take the microphone off-hook and press the PTT switch to talk and release it to listen. If scanning, a response may not automatically occur on the group of the call (see page 39).

TELEPHONE CALLS AND

OTHER SPECIAL CALLS

Placing Telephone Calls

NOTE: Telephone calls can be placed and received only if that service is available to you and your transceiver has been programmed appropri- ately. A microphone equipped with a telephone keypad is required to dial the telephone number.

The telephone calling feature allows you to place and receive tele- phone calls using your transceiver. The following information describes how these calls are made with Multi-Net and LTR operation. If you can make telephone calls with conventional operation, the procedure may be somewhat different and your system operator will then provide additional information. Proceed as follows:

1.Turn transceiver power on and set the volume as described starting on page 15.

2.Select the system and group programmed for telephone calls. When a

telephone or Multi-Net special call group is selected, is displayed.

3.To obtain the dial tone, briefly press the PTT switch. If the proceed tone is used, press the PTT switch until a beep sounds. If a dial tone is then heard, proceed to step 4.

21