Sharp TINSE2026QSZZ operation manual Copying from the Rspf, Stream feeding mode

COPY FUNCTIONS

COPYING FROM THE RSPF

Note	•	If "AUDITING MODE" (p.95) is enabled, enter your 5-digit account number.
	•	If the RSPF is disabled in the administrator settings, the RSPF cannot be used. See "6. SYSTEM SETTINGS
		(ADMINISTRATOR)".

1 Make sure that an original has not been left on the document glass and then close the RSPF.

If an original remains on the document glass after a copy was made,

"REMOVE THE ORIGINAL FROM THE DOCUMENT GLASS." will appear in the touch panel.

2 Adjust the original guides to the size of the original.

3 Place the originals face up in the document feeder tray.

Insert the originals all the way into the feed slot. The original size appears in the touch panel.

• Up to 100 pages (24 lbs. (90 g/m2)) can

Note be inserted at once. The stack of originals must not be higher than the indicator line on the tray.

•If the original size is not automatically detected, manually set the original size. (p.48)

• To load paper, see "LOADING PAPER"

Note (p.16). If you change the paper size in the tray, you will also need to change the tray's paper size and paper type settings. (p.20)

•If needed, manually select the paper tray that has the desired size of paper as explained on page 22.

•The paper types for the auto paper selection function can be selected, or the function disabled, in the administrator settings. (See "6.

SYSTEM SETTINGS (ADMINISTRATOR)".)

•If the original size is larger than the paper size, the result of copying from the document glass may differ from the result of copying from the RSPF. (p.23)

5 Select the number of copies and any other desired copy settings, and then press the [START] key ( ).

LOGOUT

UT

•The number in the copy quantity display will decrease by 1 each time a copy is made.

•If you are only making a single copy, the copy can be made with the copy number display showing "0".

•To clear a mistake, press the [CLEAR] key ().

•	Press the [CLEAR] key ( ) to stop
Note	copying in the middle of a run.

•If copying stops because the tray has run out of paper, you can resume copying by touching the [PAPER SELECT] key and selecting the bypass tray or a paper tray that has the same size and type of paper loaded in the same orientation.

4 Make sure that the same size of paper as the original is selected.

The selected tray is highlighted. If none of the trays have the same size of paper as the original, "LOAD xxxx PAPER." will appear.

Even if the message above is displayed, copying can be performed using the selected paper tray.

Stream feeding mode

If stream feeding mode is enabled in the administrator settings, "SET ORIGINALS FOR STREAM FEEDING." will appear in the touch panel for approximately 5 seconds after the originals are fed. Any new originals placed in the RSPF while this message appears will be fed and copied automatically.

Copying a large number of originals

Job Build mode is useful when you need to copy more originals that can be placed in the RSPF at once. For information on Job Build mode, see "JOB BUILD MODE" (p.46).

24