Sharp TINSE2026QSZZ Touch the Output key, Touch the Sort or Group key Touch the OK key

CONVENIENT COPY FUNCTIONS

1 Place the originals in the RSPF or on the document glass. (p.23, p.24)

If originals are placed in the RSPF, the sort function is automatically selected. (To disable this function, see the "6.

SYSTEM SETTINGS (ADMINISTRATOR)".)

Example: 5 sets of copies or 5 copies per page of 3 originals

Originals

2 Touch the [OUTPUT] key.

2-SIDED COPY

OUTPUT

3 Touch the [SORT] or [GROUP] key.

5 Touch the [OK] key.

OK

OFFSET

6 Select the number of copies and any other desired copy settings, and then press the [START] key ( ).

LOGOUT

UT	3
7 [When using the RSPF:]

Copying will start after all the originals are scanned.

[When using the document glass:]

Replace the original with the next original and press the [START] key (). Repeat this step until all originals have been scanned, and then touch the [READ-END] key.

PLACE NEXT ORIGINAL. PRESS [START].

WHEN FINISHED, PRESS [READ-END].

READ-END

4 Touch the output tray that you wish to use.

The copies are grouped as follows:

The output tray can only

UPPER

TRAYbe selected when a job separator or finisher is installed.

CENTER

TRAY

Sort

Copy

5 sets of copies

Group

Copy

5 copies per page

To enable the offset function (p.36), touch the Note [OFFSET] checkbox so that a checkmark

appears. To disable the offset function, touch the [OFFSET] checkbox again to clear the checkmark.

If the memory becomes full while scanning the originals, "MEMORY IS FULL. PRESS [START] TO BEGIN COPYING OR [CA] TO CANCEL." will appear. To copy only the originals that have been scanned, press the [START] key () . To cancel the job, press the [CLEAR ALL] key ().

The number of originals that can be scanned into Note memory can be increased by increasing the

memory allocation in the administrator settings, or by installing more memory. (See "6. SYSTEM SETTINGS (ADMINISTRATOR)".)

37