Sharp TINSE2026QSZZ JOB Build Mode, Touch the JOB Build key in the special modes menu screen

CONVENIENT COPY FUNCTIONS

JOB BUILD MODE

Use this function when you need to copy more originals than can be placed in the RSPF at once. (The maximum number of originals that can be placed in the RSPF at once is 100.)

• If the memory becomes full while scanning the originals, "MEMORY IS FULL. PRESS [START] TO BEGIN

Note COPYING OR [CA] TO CANCEL." will appear. To copy only the originals that have been scanned, press the [START] key () . To cancel the job, press the [CLEAR ALL] key ().

•Depending on the content of the originals, the memory may become full before 100 originals have been scanned. In this case, press the [START] key () to copy the originals that have been scanned, and then place the originals that weren’t scanned in the RSPF once again and repeat the copy procedure.

•To increase the number of originals that can be scanned, install more memory or increase the memory allocation in the administrator settings. (See "6. SYSTEM SETTINGS (ADMINISTRATOR)".)

Example: Copying 130 sheets (8-1/2" x 11" size originals)

Originals

page 1

page 101

100 sheets 30 sheets

*Divide the originals into sets so that each set is no more than 100 pages. Scan the sets in order beginning from the first page of set A.

1 Touch the [JOB BUILD] key in the special modes menu screen.

		D	The [JOB BUILD] key is
			highlighted.
T	ERASE
			The job build copy icon
			( ) will also appear in
	JOB
Y		MUL	the screen to indicate
	BUILD

that the function is enabled.

2 Touch the [OK] key in the special modes screen.

You will return to the

OK	main screen of copy
DUAL PAGE 1/2	mode.
ERASE
COPY
JOB
MULTI SHOT
BUILD

3 Place the original(s) in the RSPF.

(p.24)

4 Make sure that a suitable paper size is selected, select the number of copies and any other desired copy settings, and then press the [START] key ( ) .

		Scanning begins. When
		scanning of the first set
		of originals (A in the
		above example)	is
	LOGOUT	finished, insert the
		second set and press the
UT		[START] key (	).

Repeat this step until all the remaining originals (B in the above example) have been scanned.

Remove each scanned set of originals before inserting the next set.

5 Touch the [READ-END] key.

Copying begins.

PLACE NEXT ORIGINAL. PRESS [START].

WHEN FINISHED, PRESS [READ-END].

READ-END

To cancel the job build mode function, touch Note the [JOB BUILD] key in the special modes

screen so that it is no longer highlighted. (See the screen of step 1.)

46