Sharp TINSE2026QSZZ Misfeed in the Upper Exit Area, Misfeed in AN Output Tray, 133

TROUBLESHOOTING AND MAINTENANCE

MISFEED IN THE UPPER EXIT AREA

(when a job separator tray kit or finisher (MX-FN13) is installed)

If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area.

1 Open the upper right side cover.

2 Gently pull the misfed paper out.

Be careful not to tear the misfed paper during removal.

3 Close the upper right side cover.

Make sure that the misfeed message is cleared.

MISFEED IN AN OUTPUT TRAY

(when a finisher (MX-FN13) is installed)

1 Open the front cover. 4 Slide the finisher back to the right.

2 While pressing the lever over to the	5 Close the cover.
left, slide the finisher to the left until it	7
stops.
Gently slide the finisher
until it stops.

3 Turn roller rotating knob in the direction of the arrow to remove the misfed paper.

133