Sharp TINSE2026QSZZ operation manual 108

SYSTEM SETTINGS (ADMINISTRATOR)

OUTPUT TRAYS

(When a JOB SEPARATOR TRAY KIT or FINISHER and Right tray are installed)

This program is used to select the respective output trays for the copy, printer, and fax functions.

The factory default setting is "PATTERN 1". Example:When a FINISHER and Right tray are

installed

*Settings that can be selected vary depending on the options that are installed.

Settings	Description
PATTERN 1	Printer: Offset tray
	Fax: Right tray
	Copy: Offset tray
PATTERN 2	Printer: Right tray
	Fax: Right tray
	Copy: Offset tray
PATTERN 3	Printer: Offset tray
(When the fax	Fax: Right tray
function is enabled)	Copy: Offset tray

DISABLING OF OFFSET

(When the FINISHER is installed)

This program is used to enable or disable the offset functions of the offset tray.

This program is initially disabled (factory default setting).

MEMORY FOR PRINTER

This program is used to set the amount of IMC memory that is allocated to the printer function. The amount of memory can be set from 30% to 70% in increments of 10%.

The factory default settings are as follows:

•50 (%)

•THE MEMORY AREA FOR PRINT HOLD: 30 (%)

●Memory allocated to print hold

(When the PRINTER EXPANSION KIT is installed) To set the amount of memory allocated to print hold, touch the [THE MEMORY AREA FOR PRINT HOLD] key. The amount of memory can be set from 30% to 70% in increments of 10%. If 0% is selected, the print hold function cannot be used.

DISABLING OF CENTER TRAY COUNTING

This program is used to disable counting of pages delivered to the center tray.

When this program is enabled, center tray full detection does not take place.

This program is initially disabled (factory default setting).

RETURN FROM COPY MODE TIMING

(When the printer function or fax function is enabled)

This program is used to set the amount of time that must elapse after a copy job is finished before the printer or fax function resumes operation. The amount of time can be set from 1 second to 60 seconds in increments of 1 second.

The factory default setting is "60" (sec.).

MIX SIZE ORIGINAL FEEDING MODE

When this program is enabled, originals of mixed length (the widths must be the same) can be scanned in copy mode and each original copied onto the corresponding length of paper.

This program is initially disabled (factory default setting).

SECURITY SETTINGS

The following settings are related to security. Touch the [SECURITY SETTINGS] key to configure the settings.

When any of these settings are changed, you must exit the administrator settings, turn off the main switch, wait a brief interval, and then turn the main switch back on to make the new settings take effect.

●SSL SETTINGS

SSL can be used for data transmission over a network.

SSL is a protocol that enables the encryption of information communicated over a network. Encrypting data makes it possible to transmit and receive sensitive information safely.

•HTTPS: Apply SSL encryption to HTTP communication.

•IPP-SSL: Apply SSL encryption to IPP communication.

●ENABLE IPsec

IPsec can be used for data transmission/reception on a network. When IPsec is used, data can be sent and received safely without the need to configure settings for IP packet encryption in a Web browser or other higher-level application.

This setting is only used to enable or disable IPsec; detailed IPsec settings are configured in the Web pages.

Some Web page settings may not allow connection to the machine, or the settings may not allow printing, scanning, or Web page display. In this case, deselect [ENABLE IPsec] in this screen and change the Web page settings.

SYSTEM SETTINGS

SECURITY SETTINGS OK

SSL SETTINGS

ENABLE IPsec

108