Sharp TINSE2026QSZZ operation manual Erase Copy, Touch the Erase key in the special modes screen

CONVENIENT COPY FUNCTIONS

ERASE COPY

The erase function is used to erase the shadow lines on copies that are produced when copying thick originals or books. The erase modes that can be selected are shown below. The erase width is initially set to 1/2".

1 Touch the [ERASE] key in the special modes screen.

			The erase setting screen
			will appear.
FT	ERASE		The erase icon ( , etc.)
			will also appear in the
			screen to indicate that
	JOB
PY		MU
	BUILD		the function is turned on.

2 Select the desired erase mode.

			Select one of the three
ERASE
			erase modes. The
EDGE	CENTER	EDGE+CENTER
ERASE	ERASE	ERASE	selected key will be

highlighted.

EDGE ERASE

Eliminates shadow lines around the edges of copies caused when heavy paper or a book is copied.

CENTER ERASE

Eliminates shadow lines produced by the bindings of bound documents.

EDGE + CENTER ERASE

Eliminates both the shadow lines around the edges of copies and the shadow at the center.

3

4 Touch the [OK] key in the special modes screen.

You will return to the main screen of copy mode.

About the steps that follow

If the document glass is being used, see page 23. If the RSPF is being used, see page 24.

•	This feature cannot be used with
Note	non-standard size originals.

•This feature cannot be selected when mixed feeding (p.26) is used.

•To cancel the erase copy function, touch the [CANCEL] key in the erase setting screen. (See the screen of step 3.)

3 Adjust the erase width as needed and touch the [OK] key.

CANCEL	OK	Use the	and	keys
		to adjust the erase width.
EDGE		The erase width can be
1/2 inch(0 1)		set from 0" to 1" in
		increments of 1/8".

43