Sharp TINSE2026QSZZ operation manual Display Messages, 117, Message Cause and solution

DISPLAY MESSAGES

If one of the following messages appears in the display, take prompt action as instructed by the message.

Message	Cause and solution	Page
ENTER YOUR ACCOUNT	Auditing mode is enabled. Enter your account number.	95
NUMBER.
A MISFEED HAS OCCURRED.	Remove the misfeed as explained in "MISFEED REMOVAL".	127
2-SIDED COPIES CANNOT BE	This appears when you attempt to make two-sided copies on special
MADE ON THIS PAPER TYPE.	paper that cannot be used for two-sided copying. Cancel two-sided	16, 28
	copying or change the paper.
REMOVE PAPER FROM THE	The indicated output tray is full. Remove the output from the tray.	-
<*>TRAY.	(<*> indicates the tray that is full.)
CLOSE THE <**> COVER.	The indicated cover is open. Close the cover. (<**> indicates the	-
	cover that is open.)
PLEASE EXTEND BYPASS-TRAY.	When copying from the bypass tray, be sure to pull out the bypass	19
	tray extension.
COVER SHEETS MUST BE THE	When adding a cover, load paper in the bypass tray that is the
SAME SIZE AS THE COPY	same size as the paper in the tray selected for copying.	49
PAPER USED.
PREPARE A NEW ONE.	The toner cartridge must be prepared.	134
TONER SUPPLY IS LOW.	The toner cartridge must be replaced soon.	134
CHANGE THE TONER CARTRIDGE.	The toner cartridge is out of toner. Replace the toner cartridge.	134
CHECK THE TONER CARTRIDGE.	Make sure that the toner cartridge is installed correctly.	134
THE DOCUMENT FEEDER IS	The RSPF has been disabled in the administrator settings. Use	23
DISABLED.	the document glass.
SELECTED PAPER TRAY IS	This appears when a tray is selected that has been prohibited in
PROHIBITED. PLEASE SELECT	"TRAY SETTINGS" in the system settings.	92
ANOTHER PAPER TRAY.
PLEASE CHECK THE PAPER	The tray's paper size setting is different from the actual paper size.	16
SIZE OF TRAY <***>.	Load the correct size of paper. The tray is indicated in <***>.
ADD STAPLES.	The finisher is out of staples. Replace the staple cartridge as	135
	explained in "STAPLE CARTRIDGE REPLACEMENT".
PLEASE REMOVE PAPER FROM	Paper remains in the stapler compiler. Remove the paper.	133
THE STAPLER COMPILER.
MEMORY IS FULL. PRESS [START]	The memory becomes full while scanning originals. Press the
TO BEGIN COPYING OR [CA] TO	[START] key ( ) to copy only the originals that have been	-
CANCEL.	scanned, or press the [CLEAR ALL] key ( ) to cancel the job.

7

117