Sharp TINSE2026QSZZ operation manual Programs for Copy Mode, Copy Settings, 110

PROGRAMS FOR COPY MODE

This chapter explains the administrator settings that are used for copy mode.

COPY SETTINGS

SYSTEM SETTINGS

COPY FUNCTION SETTINGS OK

EXPOSURE ADJUSTMENT

This program is used to adjust the exposure level when "Auto" is used for the copy exposure.

The auto exposure level can be set separately for the

INITIAL STATUS SETTINGS

ROTATION COPY SETTING

1/3

document glass and RSPF.

[1] is the lightest level and [5] is the darkest level.

The factory default settings are as follows:

EXPOSURE ADJUSTMENT

AE:3

AE:3

• Document glass: 3

• Document feeder: 3

"COPY SETTINGS" consists of the following programs:

●INITIAL STATUS SETTINGS

●ROTATION COPY SETTING

●EXPOSURE ADJUSTMENT

●AUTO PAPER SELECTION SETTING

●SETTING A MAXIMUM NUMBER OF COPIES

●SORT AUTO SELECT

●DISABLING DELETION OF JOB PROGRAMS

●CARD SHOT SETTINGS

AUTO PAPER SELECTION SETTING

This program is used to select the paper type* that is used when the automatic paper selection function operates. "PLAIN PAPER" or "PLAIN AND RECYCLE PAPER" can be selected. Auto paper selection can also be disabled with this program.

The factory default setting is "PLAIN PAPER".

*The paper type set for each tray in the tray settings of the system settings (general). (See "5. SYSTEM SETTINGS (GENERAL)".)

INITIAL STATUS SETTINGS

The copy settings revert to the default settings when the power switch is turned on, when the [CLEAR ALL] key () is pressed, or when the auto clear time elapses. This program is used to change the default settings, or return changed default settings to the initial factory default settings.

Defaults for the following copy settings can be

changed:
• Paper tray	• Exposure mode
• Copy ratio	• Duplex function

•Post-processing functions* (non-sort, sort, staple sort, and group)

*Settings for the post-processing functions vary depending on whether or not a FINISHER is installed.

If this program is used to change the default Note setting for the duplex function to other than

"one-sided" "one-sided" and the RSPF fails or is disabled, the setting will revert to "one-sided" "one-sided".

*DISABLING OF DOCUMENT FEEDER (p.107) DISABLING OF DUPLEX (p.107)

SETTING A MAXIMUM NUMBER OF COPIES

This program is used to set the maximum number of copies that are allowed per original.

Any number from 1 to 999 can be set for the maximum.

The factory default setting is "999".

SORT AUTO SELECT

This program can be used to disable automatic selection of the sort function.

This program is initially enabled (factory default setting).

DISABLING DELETION OF JOB PROGRAMS

This program is used to prevent copy settings stored in job programs from being changed or deleted.

This program is initially disabled (factory default setting).

ROTATION COPY SETTING

When this program is enabled, the original image is automatically rotated 90 degrees in the event that the original and the paper are in different orientations. (Rotation can only take place when auto paper selection and automatic ratio selection are used.) This program is initially enabled (factory default setting).

CARD SHOT SETTINGS

This program is used to set the initial original card size for the card shot function. Entry of the X dimension (width) is initially selected. Touch the keys to enter the Y dimension (length) in the same way. To have "FIT TO PAGE" be initially selected when the card shot screen is opened, touch the [FIT TO PAGE] key.

110