Sharp TINSE2026QSZZ Laser Information, Do not touch the photoconductive drum green portion

Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. Also make certain the outlet is properly grounded.

Note	Connect the machine to a power outlet which is not used for other electric appliances. If a lighting fixture is
	connected to the same outlet, the light may flicker.

Be sure to allow the required space around the machine for servicing and proper ventilation.

	12" (30cm)
12"	12"
(30cm)	(30cm)

CAUTION:

Do not install the machine in a location with poor air circulation.

A small amount of ozone is created inside the machine during printing. The amount of ozone created is not sufficient to be harmful; however, an unpleasant odor may be noticed during large copy runs, and thus the machine should be installed in a room with a ventilation fan or windows that provide sufficient air circulation. (The odor may occasionally cause headaches.)

* Install the machine so that people are not directly exposed to exhaust from the machine. If installed near a window, ensure that the machine is not exposed to direct sunlight.

Note:

The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m3) calculated as an 8 hr. time- weighted average concentration.

However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the machine in a ventilated area.

CAUTIONS ON HANDLING THE MACHINE

Observe the following precautions when handling the machine to maintain top performance.

Do not drop the machine, subject it to shock or strike it against any object.

Store spare toner cartridges in a cool dry place without removing from the package before use.

•If they are exposed to direct sunlight or excessive heat, poor copies may result.

Do not touch the photoconductive drum (green portion).

•Scratches or smudges on the drum will cause dirty copies.

Safety precautions:

This Digital Copier is rated Class I and complies with 21 CFR 1040.10 and 1040.11 of the CDRH standards. This means that the machine does not produce hazardous laser radiation. For your safety, observe the precautions below.

•Do not remove the cabinet, operation panel or any other covers.

•The machine’s exterior covers contain several safety interlock switches. Do not bypass any safety interlock by inserting wedges or other items into switch slots.

This product utilizes a CR coin Lithium battery which contains a Perchlorate material. Special handling for this material may apply, California residents, See www.dtsc.ca.gov/hazardouswaste/perchlorate/

Others, consult local environmental officers.

LASER INFORMATION

Wave length	785 nm +10 nm
	-15 nm
	North America:	26 cpm model: (6.213 µs)/7 mm
Pulse times		31 cpm model: (7.385 µs)/7 mm
	Europe:	26 cpm model: (6.213 µs)/7 mm
		31 cpm model: (7.385 µs)/7 mm
Output power	Max. 0.9 mW

5