Sharp TINSE2026QSZZ operation manual Touch the JOB Build key

NETWORK SCANNER FUNCTION

SCANNING A LARGE NUMBER OF ORIGINALS (when an RSPF is installed)

If you have a large number of originals, the originals can be scanned in batches using the RSPF.

1 Make sure the machine is in scanner mode and then load the document in the RSPF. (p.72)

2 Touch the [ORIGINAL] key.

RESOLUTION

TIFF-G4

FILE FORMAT

AUTO 8½X11

ORIGINAL

3 Touch the [JOB BUILD] key.

					If you wish to rotate the
RIGINAL SIZE
				OK	original 90° when creating
	MANUAL
					an image file, touch the
					[ROTATE THE IMAGE 90
	2-SIDED		JOB
	TABLET		BUILD		DEGREES] checkbox (a
					checkmark should appear
		ROTATE THE IMAGE 90 DEGREES
					in the box).

If the correct original size does not appear in Note the screen of step 2, touch the [MANUAL] key

5 Perform steps 4 through 9 of "BASIC TRANSMISSION METHOD". (p.72 to 73)

6 Press the [START] key ( ).

Scanning of the originals begins. A message appears in the touch panel.

7 When all of the originals in the RSPF

have been scanned, load the next batch and press the [START] key ( ).

Repeat this sequence until all pages have been

scanned.4

Note If no action is taken for one minute, scanning

automatically ends and transmission begins.

8 When all originals have been scanned, touch the [READ-END] key.

and specify the correct original size (p.78).

4 Touch the [OK] key.

You will return to the

NAL SIZE	OK	initial screen.
MANUAL
2-SIDED	JOB
TABLET	BUILD

ROTATE THE IMAGE 90 DEGREES

ESS [START].

EAD-END].

READ-END

"SENDING. PRESS [C] TO CANCEL." appears in the touch panel and transmission begins. When transmission is finished, "SENDING COMPLETED." appears in the touch panel.

• Job build mode turns off after transmission is finished. Job build mode can also be canceled by pressing the

Note [CLEAR ALL] key ( ).

• When performing Scan to E-mail, see the notes on page 74.

77