Rival GC8250-I manual Fitting Of A Plug - For U.K. And Ireland Only, Before Use, Servicing

GC8250-I/GC8250I04M1.qxd 6/16/04 11:28 Page 2

risk of injury to persons and or damage to the unit.

•Do not use sharp objects or utensils inside the Canister. Sharp objects will scratch and damage the inside of the Canister. A rubber spatula or wooden spoon may be used when the appliance is turned off.

Servicing

•Should the appliance stop working, first check the fuse in the plug (UK only) or fuse/circuit breaker at the distribution board to ensure it is operating, before contacting the manufacturer or service agent.

•If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to

avoid hazard.

THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT USE THE APPLIANCE FOR OTHER THAN THE INTENDED USE.

FITTING OF A PLUG - FOR U.K. AND IRELAND ONLY

If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Please refer to "Installation of a plug" below.

Installation of a plug - Applicable to U.K. and Ireland

The wires in the mains lead are coloured as such:

BROWN	-	LIVE
BLUE	-	NEUTRAL

Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows:

The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED.

The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK.

DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal plug is marked with the letter "E",

or with the earth symbol, or coloured GREEN, or GREEN and Yellow.

KNOW YOUR SOFT SERVE ICE CREAM MAKER

1.	Locking Latch	3	2
		4
2.	Motor Housing
3.	Indicator Light	5
4.	I (On)/0 (Off) Rocker Switch		1
5.	Top Cover	6
6.	Locking Latch
7.	Mouth		12
8.	Canister Lid
		7	13
9.	Rubber Sealing Ring
		8	14
10.	Dasher Assembly
11.	Screw	9	15
12.	Dispensing Button
13.	Dispensing Opening	11
14.	Dispensing Valve	10
15.	Canister Lid Tube
16.	Canister		16
17.	Canister Collar
			17

Before Use

1.Remove all packing materials and manual. Make sure to save manual.

2.Wash the Soft Serve Ice Cream Maker, except for the motor housing, in warm soapy water (see p. 7 - How to clean your soft serve ice-cream maker). Rinse and dry all parts thoroughly. The Rubber Sealing Ring will need to be thoroughly dried before assembling.

NOTE: Never immerse Motor Housing in water or any other liquids.

NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician.

If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 3A fuses must be BSI or ASTA BS1362 approved.

3 amp

Never wash the Canister in the dishwasher.

2 3