SECTION 5: MAJOR COMPONENTS
FIGURE 11: Major Component Descriptions
Burner with Tube Gasket | Reflector |
Must be installed with the | (Aluminum or |
flame observation | Stainless |
window facing down. | Steel) |
| Alternate overlap as |
| shown on overview and |
| on Page 16, Figure 14. |
| Minimum overlap is 6" (16 cm). |
Burner Tube | Tube | |
Supplied in 10' | ||
Hot Rolled or Heat | ||
(3 m) lengths. Burner | ||
Treated Aluminized Tube | ||
tube is always the first tube | ||
Supplied in 10' (3 m) lengths. | ||
after the burner. | ||
| ||
Reflector End Cap | Coupling Assembly | |
Punch out center | with Lock | |
section to |
| |
accommodate tube. |
|
Tube and Reflector Hanger with Clamp Package Position this hanger no more than 4" (10 cm) away from the burner.
Tube and Reflector Hanger Suspend system from these hangers.
Reflector Support Strap & Wire Form
Flex Gas Line with
Shut Off Cock
Flexible Boot Flexible boot is used to connect the last tube to the vent.
Vent Sleeve
Vent Sleeve installed inside flexible boot.
Turbulator Turbulator must be installed in the last standard section of tube. Turbulator is not required on the
8