Roland F-100 If the Stand is Uneven, To stabilize the pedals, When Moving the Instrument

Introduction

4.Tighten the screws on the side panels to secure that side panel the F-100 and speaker box (four

locations).

fig.st03-2

Screws

5.Stand the instrument back up.

When lifting the instrument back up, grasp near the center of the speaker box and the F-100, and gently raise

the instrument.

fig.st03-2

If the Stand is Uneven

If after lifting the F-100 back up you find that stand is crooked, try loosening the screws and then securing them again. When retightening, start with the top screws, then work your way down. When doing this, slightly loosen the screws before firmly tightening them.

To stabilize the pedals

Temporarily loosen the screws that fasten the pedal board.

Step on the pedal, and after verifying that the pedal is in firm contact with the floor, re-tighten the screws firmly.

6.Place the caps over the heads of the screws (five

on each side).

fig.st03

Caps

7.Connect the speaker cable extending from the rear of the speaker box to the F-100’s speaker connector.

Press the speaker cable completely into the connector so

that it is securely fastened.

fig.st04

F-100 Rear

Clip Portion Speaker Connecter

Speaker cable

Hold and insert the cable so that the clip portion extends into the stand and is securely connected.

8.Connect the pedal cables to the Pedal [Damper] jack and [Soft] jack.

Connect the brown plug to the Damper jack, and the black plug to the Soft jack.

9.As necessary, affix cord cramps as shown in the

diagram to fasten the pedal cable.

fig.st04

Cord Cramps

Pedal Cord

When Moving the Instrument

Disconnect the AC cord, cables, the music stand and the lid from the F-100.

Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught.

Check the stability of the pedal, and make adjustments as necessary.

When Disassembling

Disassemble the unit by carrying out assembly Steps 1-8 in reverse order.

When Changing the Orientation of the Speaker Box

Be sure to completely disassemble the unit, change the

speaker box orientation, then reassemble it.

7