Roland FP-2 owner manual Before You Play, Making Connections

Before You Play

Making Connections

1. Before you begin making connections, confirm the following.

Is the volume level of the FP-2 turned all the way down?

Is the power to the FP-2 turned off?

2. Connect the supplied Power Cord to the supplied AC adaptor.

fig.00-01

AC adaptor Power cord

Power outlet

3. Connect the supplied AC adaptor to the FP-2, and then plug its other end into a power outlet.

4. Loop the AC adaptor cord around the cord hook to fasten it in place.

fig.00-02

Rear Panel

ground terminal

cord hook

927

To prevent the inadvertent disruption of power to your unit (should the plug be pulled out accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power cord using the cord hook, as shown in the illustration.

Depending on the circumstances of a particular setup, you may experience a discomforting sensation, or perceive that the surface feels gritty to the touch when you touch this device. This is due to an infinitesimal electrical charge, which is absolutely harmless. However, if you are concerned about this, connect the ground terminal (see figure) with an external ground. When the unit is grounded, a slight hum may occur, depending on the particulars of your installation. If you are unsure of the connection method, contact the nearest Roland Service Center, or an authorized Roland distributor, as listed on the “Information” page.

Unsuitable places for connection

•Water pipes (may result in shock or electrocution)

•Gas pipes (may result in fire or explosion)

•Telephone-line ground or lightning rod (may be dangerous in the event of lightning)

8