Roland FP-3 owner manual Installing the Music Stand, Before You Play

Before You Play

2. Connect the supplied AC adaptor to the FP-3, and then plug

its other end into a power outlet.

To prevent the inadvertent disruption of power to your unit (should the plug be pulled out accidentally), and to avoid applying undue stress to the DC In jack, anchor the power cord using the cord hook, as shown in the illustration.

Rear panel

On Off

Power

DC In 9V

3. Connect the amp or audio gear to the Line Out jacks as

shown in the diagram.

In order to take full advantage of the FP-3’s sound we recommend that you play it in stereo.

When using the system in mono, connect to the Line Out L (Mono) jack.

→If you are using headphones, refer to “Connecting Headphones” (p. 11).

→For instructions on connecting to the Pedal jacks, refer to “Connecting Pedals” (p. 10).

→For instructions on connecting to the MIDI connectors, refer to “Connecting MIDI Devices” (p. 42).

Installing the Music Stand

1. Using the supplied screws, fasten the music stand to the

back of the FP-3 as illustrated.

Be sure to use the supplied screws for attaching the music stand.

Turn the screws clockwise to tighten them.

When attaching the music stand, support it firmly with one hand to make sure that you do not drop it. Be careful, so you do not get your fingers pinched.

2. To remove the music stand, support it with one hand while

loosening the screws.

NOTE

Do not apply excessive

force to the installed music

stand.

9