Recording

Setting the function of the [LIMITER] switch

1.Press [MENU] to access the “Menu” screen,

use [ ]/[ ] to select “Input Setup,” and press [ ].

2.Use [ ]/[ ] to move the cursor to the

Limiter/AGC setting, and use [ ]/[ ] to select either Limiter or AGC.

3.Press [MENU] twice to return to the main screen.

If AGC is on, INPUT [+] [–] is disabled, and you won’t be able to adjust the recording level manually.

Cutting the Low-Frequency Range

By turning on the [LOW CUT] switch on the rear panel, you can cut the low range below a specified frequency.

Normally, you can leave this off.

If you have problems with low-frequency noise, such as the wind noise that is often present in outdoor recordings, the rumble from automobiles or machines, or vibration, you may be able to reduce this noise by cutting the low-frequency range.

If you have problems with the breath noise or muffled tone that can occur when recording a vocal, cutting the low-frequency range will give you a more crisp recording.

49

Page 48
Image 48
Roland R-05 warranty Cutting the Low-Frequency Range, Setting the function of the Limiter switch