Top, Front, and Rear Panels

7

 

PAD BANK button

 

INT/EXT buttons

 

Use this button to switch pad banks. (p. 23)

 

 

These buttons switch between Internal and External

 

ROLL button

modes. Normally you will leave Internal mode selected.

 

Use this button to play a roll. (p. 30)

(p. 15)

 

 

FUNC button

 

HOLD pad

 

This pad activates the Hold function. (p. 30)

 

 

You can hold down [FUNC] and press another button or

 

 

pad to access an alternate function for that button or pad.

 

INPUT SOURCE pad
CLIP BOARD button

 

This pad sounds the audio input signal. (p. 25)

 

 

This button lets you use the clip board to copy a sample.

 

Pads [1]–[16]

(p. 32)

 

You can play samples by striking these pads. (p. 23)

 

 

SAMPLING button

 

 

Use this button to perform sampling. (p. 26, p. 42)

 

 

 

 

 

Front Panel

Memory card slot

You can insert a memory card here. (p. 22)

*You can use a Phillips screwdriver to remove the two screws immediately under each end of the card slot (i.e., on the SP- 606’s bottom panel edge closest to yourself), and use these same two screws to attach the included card theft prevention cover. This will prevent the memory card from being removed and stolen.

*When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or controls get damaged.

*When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.

18