Using the TD-10 as asound module
As shown in the following diagram, use a MIDI cable to con-
nect the TD-10’s MIDI IN to the MIDI OUT connector of an
external sequencer,keyboard or pad controller (such as SPD-
11).
fig.11-01ae
The settings discussed here are necessary only when using
the TD-10 as a MIDI sound module.
* When using the TD-10 as a 4-part sound module, the sounds
you select must be assigned to a PATTERN as the pattern para-
meters store which sounds you are using. In this case it’s best to
use an empty pattern to make these settings. (Press [PAT-
TERN]-[F4 (NEW)] to select an empty pattern containing no
performance.)

Setting the instrument for each

part

Refer to “Chapter 6. Sequencer” in the section “Settings for
part instruments” (p. 106).
If you wish to select instruments for the backing parts (Part
1, Part 2 , Bass part) from an external MIDI device, transmit
program changes (PG) 1–54. These correspond to instru-
ments 1–54 of the TD-10’s backing parts.

Adjusting the mixer settings

for each part

Refer to “Chapter 6. Sequencer” in the section “Settings for
part instruments” (p. 106).

Regarding note numbers for

the drum kit sounds

Refer to “Selecting the note number transmitted by each
pad” (p. 122).

Example of settings for General MIDI score

fig.11-04e
Sequencer
MIDI OUT MIDI IN
TD-10
H 2
R 2
H 1
C2
H 5
H 4
H 6
H 3
R 3
R 4
R 8
R 9
H 9
R10
H7
H7
R6
H7
H 8
H10
TRIGGER No. TRIGGER No.
Chapter 10. Functions using MIDI
125
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10