■Correcting timing as you record

(Quantize)

Quantize is a function that corrects inaccuracies of timing
while you record. Specify the basic note value before you
begin recording,and your performance will be quantized
automatically to the set interval.
fig.07-11
Procedure
1. Press [PATTERN]-[REC].
The “REC STANDBY” page appears and you’re in record-
standby mode as the click starts to play.
2. Use [CURSOR] to move the cursor to “Quantize.”
3. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
Quantize: (8th note), (8th note triplets), (16th
note), (16th note triplets), (32nd note),
(32nd note triplets), (64th note), OFF

■Importing data from another

sequencer into the TD-10

Data created on another sequencer can be imported via the
MIDI IN and recorded on the TD-10’s sequencer. The three
melodic tracks and one drum track can be imported simulta-
neously. You will need to make settings for MIDI channels
and MIDI synchronization.
Procedure
1. Press [SETUP]-[F2 (MIDI)].
The “MIDI” page will appear.
2. Set the MIDI channel of the TD-10 to match the MIDI
channel of the transmitting device (refer to p. 124).
3. Press [PATTERN]-[F2 (FUNC)]-[F1 (GLOBAL)].
The “PATTERN GLOBAL” page will appear.
4. Use [INC/DEC] or the VALUE dial to select “Auto.”
5. Press [PATTERN]-[REC].
The “REC STANDBY” page appears and you’re in record-
standby mode as the click starts to play.
6. Use [CURSOR] to move the cursor to “Rec Mode.”
7. Use [INC/DEC] or the VALUE dial to “Replace.”
8. Begin playback on the transmitted device. The TD-10 will
begin recording in synchronization.
9. When the portion to be imported has been recorded, stop
playback on the external sequencer and the TD-10 will
stop recording.
Editing a pattern

■Naming a pattern

Each pattern can be given a name of up to 8 characters.
Procedure
1. Press [PATTERN]-[F2 (FUNC)]-[F4 (NAME)].
The “PATTERN NAME” page will appear.
2. Use [CURSOR] (left/right) to select the character you
wish to change. The blinking location is the character that
can be changed.
The blinking location is the character that can be changed.
3. Use the VALUE dial, [INC/DEC], or [CURSOR] (up/down)
to change the character.
Characters can be selected in the order shown in the bottom
of the screen.
Function buttons
In this page, the [F1]–[F4] buttons perform convenient func-
tions for entering characters.
[F1 (INSERT)]: All characters to the right of the cursor will
be moved to the right.
[F2 (DELETE)]: The character at the cursor location will be
deleted, and all characters to the right of the
cursor will be moved to the left.
[F3 (SPACE)]: A blank space will be inserted at the cursor
location.
[F4 (CHAR)]: Cycle between uppercase/lowercase/sym-
bols.
Chapter 6. Sequencer
103
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10