Display-related problems

●Trigger indicators light on their own

If a monitor speaker or the like is sounding at a high volume
nearby a pad, the vibration can sometimes be detected by
the pad as a trigger signal. If this occurs, either move the
speaker, or change the angle of the pad. Also verify the
mounting of the pads and that the stand is stable in order to
eliminate excess vibrations.

●Display is too light or too dark

The visibility of the display will change depending on the
viewing angle and on room lighting conditions. Re-adjust
the setting in the page that is displayed when you press
[SETUP]-[F3 (CTRL)]-[F3 (DISPLY)], or hold down [KIT] and
rotate the VALUE dial to make the setting.(easiest way).
Other

●Hitting [PREVIEW] plays back a pat-

tern.

Is a pad pattern assigned to the pad?

In this case, using [PREVIEW] to play this pad will have the
same result as striking the pad, and the pattern will play-
back. To stop playback, press [STOP].

●Sounds of other instruments are

audible when using the DIRECT

jacks

The ambience component of the tone being

output from a DIRECT jack is being heard from

the MASTER jack. Turn the ambience to "OFF"

(p. 41), or set the "AMBIENCE Output Level" to

"0" (p. 88).

Regardless of the sound output assignments (Output Assign;
p. 91), all of the ambience sounds are mixed into two chan-
nels, (L) and (R), and sent to the outputs selected with the
"AMBIENCE Output Level" setting (p. 88). Therefore,
sounds may be audible through a different output than the
output assigned for the instrument itself due to the "AMBI-
ENCE Output Level" setting.
For example, if the factory settings are changed so that the
kick is output from the DIRECT jack, the ambience sounds
are still to be output from the MASTER jack; as a result, the
kick sound could be perceived as seeping from the MASTER
jack.

Low-level crosstalk (-45 dB or lower) is per-

ceived at another output connector.

This is within the TD-10's specifications, so it should not be a
source for concern.
Output Separation:76 dB (min.)
(MASTER L -> DIRECT L, MASTER R -> DIRECT R): 45 dB (min.)
(DIRECT L -> Other DIRECT L, DIRECT R -> Other DIRECT R): 45 dB (min.)
Troubleshooting
135
Appendices