15
Panel Descriptions
An Overview of the TD-20
fig.rear_50
1.
POWER Switch
This switch turns the power on/off.
945
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to
Power Supply
(p. 5).
2.
AC Inlet
Connect the included AC power cable to this inlet.
* For details on the power consumption, refer to p. 103.
The unit should be connected to a power source
only of the type marked on the bottom of the
unit.
3.
TRIGGER INPUT Jacks
Here is where you plug in pads, kick triggers, or acoustic
triggers. With dual trigger pads (PD-125/120/105/80R/
9/8/7), use a stereo (TRS) cable (p. 18).
4.
MIDI IN Connector
To connect an external MIDI source (sequencer, pad
controller, keyboard, computer, etc.) to play the TD-20’s
sounds, or to load data (pp. 74–77).
5.
MIDI OUT/THRU Connector
For using the TD-20/pads to play sounds in an external
MIDI sound module, or recording/saving data to an
external MIDI sequencer (pp. 74–77).
6.
MIX IN Jack
Used for connecting any external audio source (p. 19).
This audio signal will be output from the MASTER OUT
jacks and/or PHONES jack. Other signal routing
possibilities (p. 78).
7.
FOOT SWITCH Jack
Optional foot switches (such as BOSS FS-5U) give you
access to a variety of functions like selecting drum kits,
sequencer start/stop, etc. Using an optional PCS-31 cable
(standard insert cable), two foot switches can be utilized
at the same time (p. 79).
8.
DIRECT OUT Jacks
Individual outputs have a variety of uses. The TD-20
offers many options. See the SETUP screen (p. 78).
9.
MASTER OUT Jacks
For connecting to your amp/audio system. For monaural
output, use the MASTER OUT L (MONO) jack.
10.
DIGITAL OUT Connector
This coaxial-type digital out connector sends the same
audio signal as is output from MASTER OUT jacks.
11.
Security Slot ( )
For retail store use.
http://www.kensington.com/
Rear Panel

12 8 93 4 5 7 11106

TD-20_Ref_e.book 15 ページ ２００５年５月２５日　水曜日　午前９時４９分