43
Chapter 4. Effect Settings
Chapter 4
[EFFECTS]

LO-FI

Intentionally degrades the sound quality for creative
purposes.

RING MOD

Applies amplitude modulation (AM) to the input signal,
producing bell-like sounds.
A stereo compressor (limiter)/three-band equalizer provides
final audio touches to the total sound of the TD-20. Can be
used for each kit and/or all kits.
fig.04-007_70
1.

Press [MASTER COMP/EQ].

[MASTER COMP/EQ] lights.
2.

Press [F2], [F3], or [CURSOR] to select the

parameter.

3.

Use [+/-] or [VALUE] to adjust the setting.

4.

Press [F1] to turn the master effects on.

The sound may be distorted in a certain setting.
You can use the master effect on “per kit” basis, or as a
global one (p. 80).
Parameter Value Description
Fs Rate OFF, 1/2–1/32 Sample rate
Bit OFF, 15–1 Number of bits in data
BPF Cutoff 0–100 Cutoff frequency of the
BPF (Band Pass Filter)
BPF Mix 0–127 Amount of mixing the
sound that goes through
the BPF
Parameter Value Description
Freq 0–127 Frequency at which
modulation is applied
Master Effects [MASTER COMP/EQ]
Parameter Value Description
[F2 (M COMP)]
Threshold -60–0 (dB) Volume level at which com-
pression begins
Ratio 1:1–100:1 Compression ratio
Attack 0–100 Time from when the volume
goes up the threshold level
until the compressor effect
applies
Release 0–100 Time from when the volume
falls below the threshold lev-
el until the compressor effect
no longer applies
Gain -60– +12
(dB)
Output volume of compres-
sor
[F3 (M EQ)]
Type SHELV
(Shelving),
PEAK
(MID: fixed
to “PEAK”)
SHELVE:
Entire range above/below
the selected frequency range
is boosted/cut
PEAK:
The vicinity of the selected
frequency range is boosted/
cut
Q 0.5–8.0
(only when
Type is set
to “PEAK”)
Width of the frequency
range
A higher Q narrows the af-
fected area.
Freq (Fre-
quency)
20–1k
(LOW), 20–
16K (MID),
1k–16k
(HIGH)
Point at which the boost/cut
will occur
Gain -12– +12 Amount of boost/cut
Parameter Value Description
TD-20_Ref_e.book 43 ページ ２００５年５月２５日　水曜日　午前９時４９分