MAKING BURNER ADJUSTMENTS
If you are using L.P. (bottled) gas, all the adjustments described on the previous page must be made before you make any burner adjustments or use the oven.
AII oLt;ns are factory adjusted for use with the natural gas used in most areas But since the gas In some areas may be dillerent you should check all adjustments described
below If you areusing L.P. gas, all the adjustments must be made.
K.lemove the oven boltoms as shown in the Removable Parts section of the owner s manual Remove the shlpplng wires f,orn the oven burners
Step 1: Adjust Air Shutter
|
| 2 | |
|
| INNER CONE | L P. |
|
|
| |
| 1 | OF FLAME |
|
, | i,, | BROIL |
|
|
|
| |
(i |
| ||
.a+
i urn I~ie burner lull or’ and check the flames Burner flames rhould nol llulteror blow away from the burner They should
:t‘ bltie 111color with no trace of yellow Foreign particles In !~t? gas IIne may caL’;e an orange flame al first but this ~111 loor disappear
i III~ flames are yellow or llutler.operi the air shutter more I !hey blow away from the burner close the air shutter more
t3!!:r;,:r flames ~houlri be checked frequently
To adjust air shutter:
!!:;t’ ,+screirrdrlver to lOosen the air shuller screw Adjust the <III snuller and retlgh:en the air shutter screw
/’
/
Step 2: Adjust Orifice Hood
c:heck the Inner conu of the flame It should be about 1 2’ lzng for the oven broiler burner (see below) If the length ol the inner cone of Ihe flame IS not correct, use a 1 2“open end \vrench or adjustable ]olnt pliers lo adjust the onfice hood
o sllorlen Iht? coneL, tIghten the orlflce hood by turning In 1~~2I P directIon To lengthen the cones loosen the orifice Ii?od by turning In the Nat dlrectlon (see illustrations this
AIR SHUTTER
A ACCESS OPENING COVER B ELECTRICAL CONNECTION C TRIM CLIP
D ORIFICE COVER
E OVEN IGNITOR
AIR SHUVER
SCREW
6 | GINS552 |
