Follow each
“Keep” command = press and release the left <Ctrl> key, then the “K” key.
Use only the numeric keys above the keyboard. The keypad will not work. All keyboard commands must be entered within 2 seconds of pressing and releasing the left <Ctrl> key.
Keyboard command description
Computer select
To select a computer from your keyboard, press and release the left <Ctrl> key and then type in the computer number
Next computer
To switch to the “Next computer”, press and release the left <Ctrl> key, then press the plus/equal key.
Previous computer
To switch to the “Previous computer”, press and release the left <Ctrl> key then press the minus/underscore key.
Scan mode (On)
To enable the “Scan mode”, press and release the left <Ctrl> key, then type S. The Vista switch will begin scanning sequentially from its current computer through the remaining computers (as set by the maximum computers command), and then begin again at computer 1.
Scan mode (Off)
To stop the “Scan mode”, press and release the left <Ctrl> key and then type “X”. Issuing a computer select command also turns off scanning.
Scan time interval
The “Scan Time interval” command sets the time, in seconds that the Vista switch will pause at each of the computers when scanning. The default setting is 5 seconds. To change the Scan Time to another interval press and release the left <Ctrl> key, type “T” then enter the new scan time interval
