12 DVA-3210
Installation and Wiring1. Before Starting
Read these instructions and the precautions carefully.
WARNING!
Be sure to disconnect the battery (-)
terminal before starting. This is to
prevent short circuits during installation.
Precautions
•This unit is only for cars with negative ground 12V systems.
•Do not open the case. There are no user-serviceable parts inside.
If you drop anything into the unit during installation, consult your
dealer or an authorized Rosen service center.
•Use a soft, dry cloth to clean the case.
2. Package Contents
•13-Pin Data Cable
•Installation Brackets and Assorted Hardware
•Owner’s Manual / Installation Guide
•Warranty Card
3. Installation Requirements
1 Use the enclosed screws for installation. Using other
screws can cause damage and void the warranty.
2 Before installation, remove the three transport screws
from the bottom of the unit! Use a Phillips screwdriver.
1.000
SCALE
Transport Screws -
REMOVE BEFORE INSTALLATION!
3 Install the unit in one of the three orientations shown.
Always adjust the springs as shown!
Note: Never install the DVA-3210 on end!