4. Installing the DVA-3210
Mount the unit in a dry location according to the illustrations on the previous page.
Ensure that the unit is firmly mounted and cannot come loose in the event of a collision.
Also ensure that there is sufficient clearance in front of the unit to reach the door readily, and for the magazine to fit into the loading slot.
CAUTION!WARNING!
5. Wiring the DVA-3210
Wiring the
With some Rosen and necvox units, the
Read the following precautions before wiring any system.
• Disconnect the negative battery terminal before making |
any wiring connections. |
Do not overtighten the screws on uneven sur- faces! This can cause dam- age to the unit. If an even mounting surface cannot be found, fabricate a flat panel, mount the unit to it, and mount that panel to the ve- hicle.
Always use great care when attaching anything to a vehicle! Visually inspect all sides of any potential screw location, to insure no damage will occur. If you have ques- tions about this process, see your authorized necvox dealer.
• Be particularly careful where you route wires and cables. |
Keep them away from the engine, exhaust system, etc. |
Heat may damage wires. |
• If a fuse should blow, make sure all connections are |
correct and no wires are damaged before replacing the |
fuse. Always use fuses that are the same amperage value |
as the original. When replacing a fuse, never let the battery |
side touch any metal part or any other wire. |
14
