ULTRA ATA/133 PCI RAID Card RC200 | User Manual | |
|
|
|
Note: For proper operation of the Ultra ATA 133 PCI RAID card, the jumper
must remain on.
1.Turn Off the power to your computer and any other connected peripheral devices.
2.Unplug the power cord from the back of the computer.
3.Remove your computer’s cover.
4.Remove the slot bracket from an available PCI slot.
5.To install the card, carefully align the card’s bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.
6.Replace the slot bracket’s holding screw to secure the card.
Device Connection
The UltraATA 133 RAID PCI is a dual channel Ultra ATA/133 controller that support up to for IDE hard disk drives. To achieve maximum performance and compatibility we suggest using identical hard drives in building your RAID sets.
5
