Rosewill RC200 ＊For Existing Windows NT 4.0 Installation, ＊To Verify Windows NT 4.0 Installation

ULTRA ATA/133 PCI RAID Card RC200 User Manual

7.Press Enter to continue and follow on-screen instructions to complete Windows NT 4.0 installation.

＊For Existing Windows® NT 4.0 Installation

1.Setup the RAID Array prior to driver installation.

2.Install the board and boot up Windows® NT 4.0

3.Double click My Computer/Control Panel/SCSI Adapters, then click Drivers tab.

4.Click Add… then Have Disk…

5.Insert the driver CD, type D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive you are using. If D is not letter of your CD-ROM drive, substitute D with the correct drive letter), then click OK

6.Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and click OK.

7.Click OK, restart Windows NT 4.0 to complete driver installation.

＊To Verify Windows® NT 4.0 Installation

1.Double click My Computer/Control Panel/SCSI Adapters.

2.Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller from SCSI Adapters listing and click Properties. A message this device is working properly is displayed in the dialog box, the driver has been correctly installed.

For Windows® 2000

＊For New Windows® 2000 Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk,

25